The best way to install the SlapJax. These are the two hex bits (1/8" and 5/32") that you need to install the SlapJax and hardware. Manufactured in the USA by one of the top bit makers, they are best quality 1/4" drive bits specially tempered to minimize damage to the factory screws. Slightly oversized, they maximize the amount of contact with the fastener drive pocket.
Follow the installation video for instructions. Always use gentle and careful heat on the pivot screw to soften the factory threadlocker before attempting to remove the screw. We recommend an inexpensive butane torch.
1/4" drive handles not included.
